Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) User Manual

Page 34

Fabric OS Message Reference

53-1003140-01

Changing the severity level of swEventTrap

To change the severity level of swEventTrap, perform the following steps.

1. Log in to the switch as admin.

2. Execute the snmpConfig

set mibCapability command to configure MIBs interactively. All the

supported MIBs and associated traps are displayed. You can change the DesiredSeverity for
swEventTrap to 1 (Critical), 2 (Error), 3 (Warning), or 4 (Informational). The default value is 0.

switch:admin> snmpconfig --set mibcapability

FE-MIB: YES

SW-MIB: YES

FA-MIB: YES

FICON-MIB: YES

HA-MIB: YES

FCIP-MIB: YES

ISCSI-MIB: YES

IF-MIB: YES

BD-MIB: YES

SW-TRAP: YES

swFault: YES

swSensorScn: YES

swFCPortScn: YES

swEventTrap: YES

DesiredSeverity:Informational

swFabricWatchTrap: YES

DesiredSeverity:None

swTrackChangesTrap: YES

swIPv6ChangeTrap: YES

swPmgrEventTrap: YES

swFabricReconfigTrap: YES

swFabricSegmentTrap: YES

swExtTrap: NO

swStateChangeTrap: NO

swPortMoveTrap: NO

swBrcdGenericTrap: YES

...

SW-TRAP (yes, y, no, n): [yes]

swFault (yes, y, no, n): [yes]

swSensorScn (yes, y, no, n): [yes]

swFCPortScn (yes, y, no, n): [yes]

swEventTrap (yes, y, no, n): [yes]

DesiredSeverity: (0..4) [4] 3

swFabricWatchTrap (yes, y, no, n): [yes]

DesiredSeverity: (0..4) [0] 2

swTrackChangesTrap (yes, y, no, n): [yes]

swIPv6ChangeTrap (yes, y, no, n): [yes]

swPmgrEventTrap (yes, y, no, n): [yes]

[...]

3. Execute the snmpConfig

show mibCapability command to verify the severity level of

swEventTrap.

switch:admin> snmpconfig --show mibcapability