Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 826)

804 Fabric OS Message Reference
53-1003140-01
SEC-1309
5
SEC-1309
Message
Waiting for RCS transaction to complete: secs
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that Fabric OS is still waiting for the reliable commit service (RCS) transaction to complete.
Recommended
Action
Verify if there are any reliable commit service (RCS) or Reliable Transport With Response (RTWR)
errors. If not, the transaction is still in progress.
SEC-1310
Message
Unable to determine data distribution limit of fabric. Please retry later.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the data distribution limit could not be obtained from all switches in the fabric. This may happen
if the fabric is reconfiguring or a new domain joined the fabric.
Recommended
Action
Retry the command when the fabric is stable.
SEC-1311
Message
Security mode cannot be enabled because one or more of the password policies is
not set to default value.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the security enable failed on the fabric because one or more switches in the fabric have
password policies that are not set to the default values.
Recommended
Action
Verify the security event was planned.
If the security event was planned, run the passwdCfg --setdefault command on each switch in the fabric
to set the password policies to the default values. Then verify with the passwdCfg --show command that
password policies are set to the default values on all switches and retry the secModeEnable command.