Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 161)

Fabric OS Message Reference 139
53-1003140-01
AG-1024
5
AG-1024
Message
F_Port is failed back to its preferred N_Port .
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the specified N_Port is failing back F_Ports, which are failed over to some other N_Port.
Recommended
Action
Execute the ag --mapshow command to display the updated F_Port-to-N_Port mapping.
AG-1025
Message
Port group of Slave N_Port is different than its Master N_Port
.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the port groups of the Master and Slave N_Ports are different, while the trunk area
assigned to the attached F_Ports on the edge switch is the same.
Recommended
Action
Execute the porttrunkarea --show command on the attached switch to verify that the trunk area is
assigned to all ports in the system, and execute the porttrunkarea --enable command to reconfigure the
trunk area.
AG-1026
Message
Unable to handle the login request on port due to insufficient
resources.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that there are insufficient resources to accept the login request.
Recommended
Action
Execute the configure command on the Access Gateway switch and increase the number of allowed
logins on the specified port.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.