Bl-1012, Bl-1013 – Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) User Manual
Page 203
Fabric OS Message Reference
181
53-1003140-01
BL-1012
5
BL-1012
Message
bport number> will be re-enabled in 1 minute. Message Type LOG Severity ERROR Probable Cause Indicates that the port generated an excessive number of interrupts that may prove unrecoverable to the Recommended Action Make sure to capture the console output during this process. Check for a faulty cable, small form-factor pluggable (SFP) transceiver, or device attached to the On a bladed switch, run the slotPowerOff and slotPowerOn commands to power cycle the blade. On a non-bladed switch, reboot or power cycle the switch. If the message persists, replace the blade or the (non-bladed) switch. BL-1013 Message bport number> will be re-enabled in 1 minute. Message Type LOG Severity ERROR Probable Cause Indicates that the port generated an excessive number of interrupts that may prove fatal to the switch Recommended Action Make sure to capture the console output during this process. Check for a faulty cable, small form-factor pluggable (SFP) transceiver, or device attached to the On a bladed switch, run the slotPowerOff and slotPowerOn commands to power cycle the blade. On a non-bladed switch, reboot or power cycle the switch. If the message persists, replace the blade.
switch operation. The port is disabled to prevent the control processor (CP) from becoming too busy. The
bport is the blade port; this number may not correspond to a user port number.
specified port.
operation. The port is disabled to prevent the control processor (CP) from becoming too busy. The bport
number displayed in the message is the blade port; this number may not correspond to a user port
number.
specified port.