Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 325)

Fabric OS Message Reference 303
53-1003140-01
EM-1014
5
EM-1014
Message
Unable to read sensor on ().
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the environmental monitor (EM) was unable to access the sensors on the specified
field-replaceable unit (FRU).
Recommended
Action
Reseat the FRU. If the problem persists, replace the FRU.
EM-1015
Message
Warm recovery failed ().
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that a problem was discovered when performing consistency checks during a warm boot.
Recommended
Action
Monitor the switch. If the problem persists, restart or power cycle the switch.
EM-1016
Message
Cold recovery failed ().
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that a problem was discovered when performing consistency checks during a cold boot.
Recommended
Action
Monitor the switch.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.