Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 201)

Fabric OS Message Reference 179
53-1003140-01
BL-1007
5
BL-1007
Message
blade #: blade state is inconsistent with EM. bl_cflags 0x
control flags>, slot_on , slot_off , faulty
flag>, status .
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that a failover occurred while a blade was initializing on the previously active control processor
(CP).
Recommended
Action
No action is required. The blade is reinitialized. Because reinitializing a blade is a disruptive operation
and can stop I/O traffic, you may need to stop and restart the traffic during this process.
BL-1008
Message
Slot control-plane failure. Expected value: 0x, Actual:
0x.
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that the blade has experienced a hardware failure or was removed without following the
recommended removal procedure.
Recommended
Action
Make sure that the blade is seated correctly.
If the blade is seated correctly, execute the diagPost command to make sure that Power-On Self-Test
(POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or
have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware
problems.
If the message persists, replace the blade.
BL-1009
Message
Blade in slot timed out initializing the chips.
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that the blade has failed to initialize the application-specific integrated circuit (ASIC) chips.