Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 926)

904 Fabric OS Message Reference
53-1003140-01
SULB-1039
5
SULB-1039
Message
CP has completed relocating the internal firmware image.
Message Type
AUDIT | LOG
Class
FIRMWARE
Severity
INFO
Probable Cause
Indicates that the firmware download process has completed normally on the control processor (CP).
Recommended
Action
Run the firmwareShow command to verify the firmware versions.
SULB-1040
Message
An error has occurred during relocation of the internal image on the CP.
Message Type
AUDIT | LOG
Class
FIRMWARE
Severity
WARNING
Probable Cause
Indicates that an error has occurred during the relocation of the internal image. The error may be caused
by an inconsistent internal firmware image. It may also be caused by an internal Ethernet failure.
Recommended
Action
Run the firmwareShow command to verify the firmware versions. Run the firmwareDownload
command again if the firmware is not updated.
This will cause the internal image to be relocated again. If the problem persists, contact your switch
service provider.
SULB-1041
Message
Firmware has been activated successfully on standby CP.
Message Type
AUDIT | LOG
Class
FIRMWARE
Severity
INFO
Probable Cause
Indicates that the firmwareActivate command has completed successfully on the standby control
processor (CP).
Recommended
Action
No action is required. The firmwareActivate command has completed on the standby CP as expected.
Run the firmwareShow command to verify the firmware versions.