Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 956)

934 Fabric OS Message Reference
53-1003140-01
UCST-1003
5
UCST Messages
UCST-1003
Message
Duplicate Path to Domain , Output Port = , PDB pointer =
0x.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that duplicate paths were reported to the specified domain from the specified output port. The
PDB pointer value displayed in the message is the address of the path database and provides debugging
information.
Recommended
Action
No action is required.
UCST-1007
Message
Inconsistent route detected: Port = , should be .
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that the switch detected an inconsistency in the routing database between the routing protocol
and the hardware configuration. The first port number displayed is what the hardware has configured and
the second port number displayed is what the protocol is using.
Recommended
Action
Run the switchDisable command and then the switchEnable command to reset the routing database.
Run the uRouteShow command to display the new routing tables.
UCST-1020
Message
Static route (input-area: , domain: output-area:
number>) has been ignored due to platform limitation.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the configured static route cannot be applied to the routing database because of a platform
limitation.
Recommended
Action
No action is required.