Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 179)

Fabric OS Message Reference 157
53-1003140-01
AUTH-1007
5
AUTH-1007
Message
The proposed authentication protocol(s) are not supported: port .
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the proposed authentication protocol types are not supported by the specified local port.
Recommended
Action
Execute the authUtil command to make sure the local switch supports the Fibre Channel Authentication
Protocol (FCAP) or Diffie Hellman - Channel Authentication Protocol (DH-CHAP) protocols.
AUTH-1008
Message
No security license, operation failed.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the switch does not have a security license.
Recommended
Action
Verify that the security license is installed using the licenseShow command. If necessary, reinstall the
license using the licenseAdd command.
AUTH-1010
Message
Failed to initialize security policy: switch , error .
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reboot or power cycle the switch.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.