Nortel Networks NN43001-106 User Manual
Page 564
564
Busy Tone Detection for Asia Pacific and CALA
Prompt
Response
Description
NEDC
ETH
Either end control.
FEDC
ETH
Either end control.
LD 14 - Configure Busy Tone Supervision for a new Central Office Trunk.
Prompt
Response
Description
REQ
NEW
Add new data.
TYPE
COT
Central Office trunk.
TN
l s c u
Terminal Number
Format for Large System and CS 1000E system,
where l = loop, s = shelf, c = card, u = unit.
c u
Format for Small System and Media Gateway 1000B where
c = card and u = unit.
XTRK
EXUT
Type is IPE EXUT. This includes the DXUT. (This prompt is
required only for the first unit defined on each card.)
CUST
xx
Customer number, as defined in LD 15
RTMB
Route number and Member Number
0-511 1-4000
Range for Large System and CS 1000E system.
0-127 1-4000
Range for Small System and Media Gateway 1000B.
SIGL
LOP
Loop start level 3 signaling.
TIMP
(600)
900
Termination Impedance.
BIMP
(3COM)
3CM2
600
900
Balance Impedance. In the case of AUTO_BIMP, this BIMP
value is used as a default value if an optimum AUTO_BIMP is
not found or if the AUTO_BIMP test is not complete.
AUTO_BIM
P
YES
Automatic Balance Impedance is set according to transmission
line parameters.
NO = default for new trunks.
SUPN
YES
Answer and disconnect supervision required.
-STYP
PIP
BTS
PIP BTS
Supervision Type.
Polarity Insensitive Pack.
Busy Tone Supervision.
Both options.
BTDT
(0)-7
Busy Tone Detection Table number configured in LD 97. (This
prompt is required only for the first unit defined on each card.)
CLS
(DIP)
DTN
Dial Pulse.
Digitone.
Nortel Communication Server 1000
Features and Services - Book 1 of 6 (A to B)
NN43001-106
01.04
Standard
Release 5.0
27 July 2007
Copyright © 2007, Nortel Networks
.