beautypg.com

Modular telephone relocation – Nortel Networks NN43001-106 User Manual

Page 444

background image

444

Automatic Set Relocation

Identification code
The identification code is user selectable, and can be any four-digit
number (excluding the symbols * and #). (MTR does not require this
code.)

This feature is also used to install and enable line cards to make unused
telephone locations available for telephone relocation. Adding the first
telephone on a line card by using the Service Change overlay enables that
card (if it is not already enabled). Removing the last telephone from a line
card leaves that card enabled; it does not disable the card.

Automatic Set Relocation (ASR) requires the circuit units on digital line
cards used for supplementary power to be specified as power units in LD
12. This allows the system to disable signaling to these units, while leaving
unequipped units enabled for telephone relocation. If power units are not
specified, they generate erroneous messages and may disable the entire
card.

After putting a telephone back into service, the craftsperson should wait at
least 20 seconds before using the telephone.

Modular Telephone Relocation

Modular Telephone Relocation enhances ASR to make relocating Meridian
Modular Telephones simpler and faster (by omitting the requirement for an
identification code). The following telephones support Modular Terminal
Relocation:

M2006

M2008

M2016S

M2216

M2616

When a telephone is relocated out, a relocation block is automatically built
to store the relocation information in the protected data area. The relocation
block includes the old Terminal Number (TN), the terminal ID information,
the serial number of the telephone, and feature information. If a data dump
occurs, the relocation block is not copied to the disk.

Modular Telephone Relocation uses the unique serial number and terminal
ID of the Meridian Modular Telephones (instead of the identification code) to
identify the one being relocated. This reduces the number of steps needed
for relocation.

Nortel Communication Server 1000

Features and Services - Book 1 of 6 (A to B)

NN43001-106

01.04

Standard

Release 5.0

27 July 2007

Copyright © 2007, Nortel Networks

.