Nortel Networks NN43001-106 - Manual (Page 362)

362 Audible Reminder of Held Calls
Audible Reminder of Held Calls is supported on Multiple Appearance DNs;
however, only the appearance initiating Hold will receive the reminder ring.
This feature does not operate on attendant consoles.
Feature interactions
Automatic Line Selection
The Audible Message Waiting signal is given if there is a message waiting
on whatever line is selected by Outgoing Line Selection.
Call Hold, Permanent
Permanent Hold must be enabled in LD 10 for the single-line telephone;
however, the ARHC timer takes precedence over the Permanent Hold timer.
On Hold on Loudspeaker
This feature works with the On Hold on Loudspeaker (OHOL) feature as
for normal calls on hold (that is, gives a reminder there are calls on hold).
Therefore, it is not recommended to use this feature with the OHOL feature.
Tones and Cadences
This feature allows for a definable cadence as a reminder of a held call.
With an analog (500/2500 type) telephone, the cadence is determined by
the customer’s Flexible Tones and Cadence (FTC) table for the holding
party. Ringing on an analog (500/2500 type) telephone is not affected by
definitions for the Incoming Route option. The cadence for the reminder,
and the duration between reminder rings, is always defined within the
customer’s tone table.
Feature packaging
This feature is included in base system software.
Feature implementation
Task summary list
The following is a summary of the tasks in this section:
1. LD 15 – Set duration between reminder cadences for Audible Reminder
of Held Calls.
2. LD 10 – Allow/deny Audible Reminder of Held Calls for analog (500/2500
type) telephones.
Nortel Communication Server 1000
Features and Services - Book 1 of 6 (A to B)
NN43001-106 01.04 Standard
Release 5.0 27 July 2007
Copyright © 2007, Nortel Networks
.