Nortel Networks NN43001-106 - Manual (Page 563)

Feature implementation 563
Prompt Response Description
BTDD
(BOTH)
INC
Busy Tone Detection Direction:
Both Incoming and outgoing calls (default).
Incoming calls only.
FREQ_0 350 - 655 Frequency of Busy Tone for Frequency 0 of a dual Busy Tone
Detection to be detected in Hz. Valid entries are in multiples
of 5Hz.
FREQ_1 350 - 655 Frequency of Busy Tone for Frequency 1 of a dual Busy Tone
Detection to be detected in Hz. Valid entries are in multiples
of 5Hz.
For a single busy tone FREQ_1 must be set the same as
FREQ_0.
FDLT 10 - 315 Frequency Delta. FDLT gives the tolerance of the tone to be
detected in +/- hertz. Valid entries are in multiples of 5Hz.
For dual Busy Tone Detection on the NT5D31 card, the same
maximum and minimum levels apply to both tones.
FLVL_MAX 0 - 15 Maximum Frequency Tone level to be detected. Valid entries
are in multiples of 5dBm.
For dual Busy Tone Detection on the NT5D31 card, the same
level applies to both tones.
FLVL_MIN 20 - 35 Minimum Frequency Tone level to be detected. Valid entries
are in multiples of 5dBm.
For dual Busy Tone Detection on the NT5D31 card, the same
level applies to both tones.
LD 16 - Configure trunk units and trunk timers in the Route Data Block.
Prompt Response Description
REQ NEW Add a new data block to the system.
TYPE RDB Define a new Route Data Block.
CUST xx Customer number, as defined in LD 15
ROUT Route number
0-511 Range for Large System and CS 1000E system.
0-127 Range for Small System and Media Gateway 1000B.
TKTP COT Define trunk type as Central Office.
ICOG IAO Incoming and Outgoing trunk.
CNTL YES Changes to controls or timers.
Nortel Communication Server 1000
Features and Services - Book 1 of 6 (A to B)
NN43001-106 01.04 Standard
Release 5.0 27 July 2007
Copyright © 2007, Nortel Networks
.