Nortel Networks NN43001-106 - Manual (Page 139)

Feature implementation 139
Network Speed Call
Speed Call and Network Speed Call are supported with the AC15 Recall:
Transfer from Meridian 1 on the first transfer, provided that the digits are
outpulsed on the trunk after the End-to-End Signaling Delay timer expires. If
the far end is not ready, the call will fail because no dial tone is detected by
the system.
Additional transfers are supported if the digits are outpulsed without any
treatment. For example, the route access code will be outpulsed to the far
end. No dial tone detector is assigned and no timer is started so the digits
are outpulsed immediately without checking the state at the far end.
Feature packaging
AC15 Recall: Transfer from Meridian 1 requires the following packages:
• AC15 Recall (ACRL) package 236
• International Supplementary (SUPP) package 131
• UK Program (UK) package 190
• Autodial Tandem Transfer (ATX) package 258
Feature implementation
Task summary list
The following is a summary of the tasks in this section:
1. "LD 15 – Disable the End-to-End Signaling Tone to originating party
at the EEST prompt." (page 139)
2. "LD 16 – Define the route accepting recall signal." (page 140)
3. "LD 14 – Define the AC15 trunk." (page 140)
4. "LD 11 – Define the Aries telephones." (page 141)
LD 15 - Disable the End-to-End Signaling Tone to originating party at the EEST prompt.
Prompt Response Description
REQ: CHG Change existing data block.
TYPE: FTR Customer Features and Options.
CUST Customer number
0-99 Range for Large System and CS 1000E system.
0-31 Range for Small System, Media Gateway 1000B, and Media
Gateway 1000T.
Nortel Communication Server 1000
Features and Services - Book 1 of 6 (A to B)
NN43001-106 01.04 Standard
Release 5.0 27 July 2007
Copyright © 2007, Nortel Networks
.