Westermo MR Series - Manual (Page 97)

97 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Confi gure > Ethernet > MAC Filters 4.28
These pages contain the MAC addresses used for MAC address filtering on the Configure > Ether-
net > n pages. When enabled either on the web page or using the eth macfilt ON com mand
from the command line, a received frame will only be sent up the stack if the source MAC address
or matching part thereof exists in the MAC filter table. It is possible to allow a range of addresses
by specifying only the significant portion of the MAC address in the table, e.g. macfilt 0 mac
“00042d”
to allow packets from units.
Using the Web Page(s)
#
The MAC filter number.
MAC:
The MAC address.
Using Text Commands
From the command line, use the macfiltcommand to configure or display the MAC filters. To display
current settings enter the following command:
macfilt ?
where is the number of the MAC filter.
To change the value of a parameter use the following command:
macfilt
There is only one parameter:
Parameter Values Equivalent Web Parameter
mac MAC address MAC