Westermo MR Series - Manual (Page 320)

320 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Upper layer interface #:
This parameter specifies the number of the Upper layer interface connected to this PVC. Where
the Upper layer interface is set to “XSW” this can only be “0”.
Packet size:
This parameter defines the packet size to be used for the PVC. Select the appropriate value
from the drop down list.
Window size:
This parameter defines the layer 3 window size to be used for the PVC. Select the appropriate
value from the drop down list.
Using Text Commands
To configure PVC parameters from the command line use the pvc command.
To display the settings for the specified PVC instance use the command in the form
pvc ?
where is 0 - 3.
To change the value of a parameter use the command in the form:
pvc
The parameters and values are:
Parameter Values Equivalent Web Parameter
iniface text Initiator interface (XOT only)
lcn number LCN
l2iface lapb, lapd, tcp Layer 2 interface
l2nb 0,1,2 Layer 2 interface number
ipaddr IP address Remote IP address (XOT only)
respiface text Responder interface (XOT only)
srcipent auto, eth, ppp XOT source IP address interface
srcipadd number XOT source IP address interface #
uliface pad, tpad, xsw Upper layer interface
ulnb number Upper layer interface #
psize 0, 4-10 Packet size:
0=default
4=16
5=32
6=64
7=128
8=256
9=512
10=1024
window 1-7 Window size
For example, to configure PVC 1 to use LAPD enter the command:
pvc 1 l2iface lapd