Westermo MR Series - Manual (Page 311)

311 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
NUI/NUA selection:
If both an NUI and an NUA are included in the call string, this parameter allows the unit to fil-
ter one of these out of the X.25 call request.
Using Text Commands
To configure PAD parameters from the command line use the pad command. To display the settings
for the specified PAD instance enter the command:
pad ?
where is 0 - 4.
To change the value of a parameter enter the command:
pad
The parameters and values are:
Parameter Values Equivalent Web Parameter
amacro text Auto macro
anscug CUG Answering CUG
ansnua NUA Answering NUA
cingnua NUA Calling NUA
coneventsec number None - If this parameter is non-zero, it indi cates how long a PAD can
be connected to an ASY port before generating an event
defpak number Default packet size
dorest off, on Restarts
enqcon off, on ENQ on connect
inactevent number Inactivity Event Time(s)
inacttim number Inactivity timeout (s)
ipaddr IP address Remote IP address (XOT only)
Ip_port number IP Stream port
ip_stream off, on IP Stream mode
iphdr 0,1,2 IP length header: 0=Off 1=On 2=8583 Ascii 4 byte
l2iface lapb, lapd Layer 2 interface
l2nb 0,1,2 Layer 2 interface #
lcn number LCN
lcnup off, on LCN direction
llmode off, on Leased line mode
nocalltim number No call L2 timeout (s)
nuaimode 0,1,2 NUI/NUA selection
padmode 0,1 PAD mode
profile 1-4, 50, 51,90,91 PAD profile #
prompt text PAD prompt
restdel number Restart delay (ms)
strip_tspaces off, on Strip Trailing Spaces
stxmode 0,1 STX/ETX mode
trig_str text Data trigger
Backup Parameters
bakl2iface lapb, lapd Layer 2 Interface
bakl2nb 0,1,2 Layer 2 Interface Number
baklcn number LCN
baklcnup 0,1 LCN direction