Westermo MR Series - Manual (Page 135)

135 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the dpd command to configure or display DPD settings. To display cur-
rent settings for DPD enter the command:
dpd ?
where is 0.
To change the value of a parameter use the command in the format:
dpd 0
The parameters and values are:
Parameter Values Equivalent Web Parameter
failint number Request interval on suspect link
inact number Tunnel inactivity timer (s)
maxfail number Remove IPSec SAs after this many
failed DPD requests
okint number request interval on healthy link
For example, to set the Tunnel inactivity timer to 2 minutes you would enter:
dpd 0 inact 120