Westermo MR Series - Manual (Page 364)

364 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
SCAN/SCANR Scan File System 7.2.8
The scan command performs a diagnostic check on the file system and reports any errors that are
found. For example:
scan
direct ok
sbios ok
sregs.dat ok
config.da0 ok
IR2140.web ok
image ok, data ok
OK
The scanning process may take several seconds so you should not enter any other commands until
the results are listed.
The scanr command works in a similar fashion, except that it will return ERROR if any file is in
error.
TYPE Display Text File 7.2.9
The type command is used to display the contents of a text file. The format is:
type
For example:
type config.da0
bind PAD 0 ASY 0
pad 0 l2iface LAPB
cmd 0 username westermo
cmd 0 epassword Oz57X0kd
cmd 0 hostname ss.2000r
OK
XMODEM File Transfer 7.2.10
The xmodem command is used to initiate an XMODEM file upload from the port at which the
command is entered. The format is:
xmodem
where is the name under which the file will be saved when the upload is complete.
After entering the xmodem command the unit will wait for your terminal program to start trans-
mitting the file. When the upload is complete and the file has been saved, the unit will respond with
the OK result code.
A remote XMODEM upload can also be initiated by establishing a Telnet session over ISDN, and
then issuing the xmodem command from the remote terminal.