Westermo MR Series - Manual (Page 424)

424 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
General System Commands 19
CONFIG Show/Save Confi guration 19.1
The config command is used for the following purposes to show current or stored configuration
settings, to save the current configuration or to specify which configuration is to be used when the
unit is powered up or rebooted.
The format of the config command is:
config <0|1|c>
Two separate configurations can be stored, numbered 0 and 1. The first parameter of the config
command specifies to which configuration the command applies. The letter “c” denotes the current
configuration settings, i.e. those currently in use.
The second parameter is one of the following keywords:
show displays the specified configuration (either 0, 1 or c for the current configuration) •
save saves the current settings as the specified configuration (either 0 or 1) •
powerup sets the specified configuration (either 0 or 1) to be used at power-up or reboot •
For example, to display the current configuration use the command:
config c show
The output will appear similar to the following example:
bind PAD 0 ASY 0
pad 0 l2iface LAPB
cmd 0 username Westermo
cmd 0 epassword Oz57X0kd
cmd 0 hostname IR2140
OK
The config files only contain details of those settings that are different from the unit’s default set-
tings. If you make a setting that is the same as the default setting, it will not appear in a stored con-
figuration.
To save the current settings to configuration file 1, enter:
config 1 save
To use configuration 1 when the unit is powered up or rebooted, enter:
config 1 powerup
Confi g changes counter 19.2
The config changes command shows the number of changes to the current configuration since the
unit has powered up and the initial configuration file run. Also shows the time when the config file
was last saved.