Westermo MR Series - Manual (Page 126)

126 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Confi gure > IP Routes > RIP > RIP access list 4.38
The unit has the ability to modify route metrics based upon received RIP responses. Static routes
and default routes will have their metric modified if the route fits within one of the routes found
within the RIP packet. For ethernet routes, the gateway for the route will be set to the source
address of the RIP packet. The route modifications will be enforced for 180 seconds unless another
RIP response is received within that time.
RIP packets must have a source address that is included in the RIP access list.
Using the Web Page(s)
IP address
This is a list of IP addresses that RIP packets must come from if they are to modify route met-
rics.
Using Text Commands
From the command line, the riprx command can be used to configure the RIP access list. To display
the current settings for the RIP access list enter the command:
riprx ?
where is 0.
To change the value of a parameter use the same command in the format:
riprx 0
The parameters and values are:
Parameter Values Equivalent Web Parameter
ipaddr IP address IP address
For example, to add IP address 192.56.27.45 to the RIP access list, enter:
riprx 0 ipaddr 192.56.27.45