Westermo MR Series - Manual (Page 46)

46 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
To configure TransIP parameters via the command line use the transipcommand. To display current
settings for a TransIP instance enter the command:
transip ?
where is 0 to 3.
To change the value of a parameter use the command in the format:
trnasip
The parameters and values are:
Parameter Values Equivalent Web Parameter
cmd_echo_off off, on Command echo off
escchar character Escape char
esctime number Escape time
host IP address/host name Host
keepact number Keep Alive(s)
port number TCP port
remport number TCP remote port
staycon off, on Stay connected mode
For example, to set TransIP instance 1 to use TCP port 7000 you would enter:
transip 1 port 7000