Westermo MR Series - Manual (Page 236)

236 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
MIB-II System Confi guration
Name:
The name or description of the router.
Contact:
The contact details of the person who administers the router.
Location:
The location of the router.
Trap Confi guration
Enable Enterprise Traps:
Enables and disables enterprise traps.
Enable Generic Traps:
Enables and disables generic traps.
Enable Authentication Failure Traps:
Enables and disables authentication failure traps.
Enable VRRP Traps:
Enables and disables VRRP traps.
Using Text Commands
From the command line, use the snmp command to configure or display SNMP settings. To display
current settings for an SNMP instance enter the following command:
snmp ? where is 0. At present there can only be one instance of
SNMP, i.e. 0, but the instance parameter has been included to allow for future expansion.
To change the value of a parameter use the following command:
snmp 0
The parameters and values are:
Parameter Values Equivalent Web Parameter
authtraps 0,1 Enable Authentication Failure Traps
contact text Contact
engineid alpha-numeric Engine ID
enterprisetraps 0,1 Enable Enterprise Traps
generictraps 0,1 Enable Generic Traps
location text Location
name text Name
port number Port
v1enable 0,1 Enable SNMP v1
v2cenable 0,1 Enable SNMP v2c
v3enable 0,1 Enable SNMP v3
vrrptraps 0,1 Enable VRRP Traps
For example, to set the router location “Comms room - Leeds” enter:
snmp 0 location “Comms room - Leeds”