Using text commands – Westermo MR Series User Manual
Page 198
198
6622-3201
Web Interface and Command Line Reference Guide
www.westermo.com
Using Text Commands
From the command line the advanced PPP parameters are set using the same ppp command as for
the standard parameters.
The parameters and values are:
Parameter
Values
Equivalent Web Parameter
acttries
number
Auto-activation attempts allowed
dnsport
number
DNS server port
echo
number
LCP echo request interval (s)
echodropcnt
number
Reset link after this many failed LCP echo requests
hbimsi
off, on
Heartbeat includes IMSI:
hbroute
off, on
Heartbeat selects interface from routing table
inhibitno
numbers
Inhibit auto-activation when these PPP’s are active
inhmode
0,1
Inhibit mode: 0=Inhibit if other PPP active 1=Inhibit if other PPP is
active and not OOS 2=Inhibit if other PPP is not OOS 3=Inhibit if
other PPP is connected and not OOS
ip2count
number
PING IP switchover count
ipsecadd
number
IPSec source IP from interface #
ipsecent
blank, PPP, ETH
IPSec source IP from interface
l_accm
hex number
Desired local ACCM
l_acfc
off, on
Request local ACFC
l_addr
off, on
Request IPCP local address option
l_bacp
phone number
Request BACP
l_callb
off, on
Request call-back
l_chap
off, on
Request local CHAP authentication
l_comp
off, on
Request local compression
l_md5
0,1
Local CHAP MD5: 0=Enabled 1=Disabled
l_mru
hex number
Desired local MRU
l_ms1
0,1
Local MS-CHAP Algorithm: 0=Enabled 1=Disabled
l_ms2
0,1
Local MS-CHAPv2 Algorithm: 0=Enabled 1=Disabled
l_pap
off, on
Request local PAP authentication
l_pfc
off, on
Request local PFC
l1iface
Default, Port, AAL,
ETH, L2TP, ASY
Layer 1 interface (AAL= ATM PVC)
l1nb
number
Layer 1 interface #
lscnt
number
Reboot after this many consecutive link resets
pdacttries
number
Post-disconnect activation attempts allowed
pinfreth0
off, on
Use ETH0 for PING source IP
ping_deact
number
No PING response deact delay (s)
pingint
number
PING request interval (s)
pingip
IP address
PING IP address
pingip2
IP address
PING IP address #2
pingis
off, on
Ping only if in service
pingresetint
off, on
Reset ping interval after traffic
pingsiz
number
PING size (octets):
r_accm
hex number
Desired remote ACCM
r_acfc
off, on
Request remote ACFC
r_addr
off, on
Request IPCP remote address option
r_callb
off, on
Allow remote to request call-back
r_chap
off, on
Request remote CHAP authentication