Westermo MR Series - Manual (Page 79)

79 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
To configure ADSL parameters via the command line use the adsl command. To display current set-
tings for ADSL 0 enter the command:
adsl ?
where is 0.
To change the value of a parameter use the command in the format:
adsl
The parameters and values are:
Parameter Values Equipment Web Parameter
afe isdn, isdn_ur2 AFE
debug off, on None - Sends debugging informa-
tion to the command line console
max_bpt number None - Maximum Bits/Tone Limit
oper_mode multi, ansi, etsi, g.dmt, g.lite Operational mode
rxg_oset number None - Receive Gain Offset
tnm_oset number None - Target Noise Margin Offset
txg_oset number None - Transmission Gain Offset
Note:
txg_oset, rxg_oset, tnm_oset and max_bpt should not be changed without explicit instructions
from Westermo Technical Support.