Westermo MR Series - Manual (Page 137)

137 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line use the tunsnat command to configure settings for the static NAT map-
pings.
To display current settings for a particular mapping enter the command:
tunsnat ?
where is 0 - 19, corresponding to the table entry number.
To change the value of a parameter use the command in the format:
tunsnat
The parameters and values are:
Parameter Values Equivalent Web Parameter
ipaddr IP address Map to IP address
minport 0 - 65535 Min port #
maxport 0 - 65535 Max port #
mapport 0 - 65535 Map to port