Westermo MR Series - Manual (Page 130)

130 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the route command to configure a static IP route.
To display the current settings for a particular IP route, enter the following command:
route ?
where is the number of the IP route.
To set up parameters for a static IP route, enter the command in the format:
route
The parameter options and values are:
Parameter Values Equivalent Web Parameter
actooslim number Consecutive activation failures
before applying route down time
chkoos_deact on, off Deactivate interface after success ful
activation retry
chkoos_int number Interface activation failure retry
interval (s)
deact_add number Deactivate interface #
deact_add2 number 2nd Deactivate interface #
deact_ent 0,1 Deactivate interface: 0=None
1=PPP
deact_ent2 0,1 2nd Deactivate interface: 0=None
1=PPP
dial_int 0-255 Redial delay (s)
doinact2 off, on Use 2nd inactivity timeout when
this route becomes available
gateway IP address Gateway
inact2add number Change the inactivity timeout for
this PPP #
IPaddr IP address IP address
ll_add number Interface #
ll_cfg number Interface sub-config
ll_ent “”, PPP, or ETH Interface
mask IP netmask Mask
metric 1-16 Disconnected metric
pwr_dly number Initial powerup delay
q1 off, on Enqueue only one packet during
interface connection period
rgroup number Recovery group #
srcip IP address Source address
srcmask IP netmask Source mask
unoos_add number Remove OOS on this interface #
unoos_ent PPP, ETH Remove OOS on this interface
when route deactivates
unoos_secs number Remove OOS status for this period
of time (s)
upmetric 1-16 Connected metric