Westermo MR Series - Manual (Page 132)

132 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Link with interface:
This parameter, in conjunction with the Link with interface # parameter, defines which interface
or interfaces this key is associated with. “Any” means this key can be used by any interface,
“PPP” means the key can only be used by the PPP interface instance number defined in Link
with inter face #, and “Ethernet” means the key can only be used by the Ethernet interface
instance number defined in Link with interface #.
Link with interface #:
See above.
Using Text Commands
From the command line, use the ripauth command to configure or display the RIP authentication
key settings.
To display the current settings for a RIP authentication key enter the following command:
ripauth ?
where is the instance of the RIP authentication key. To change the value of a param-
eter use the following command:
ripauth
The parameters and values are:
Parameter Values Equivalent Web Parameter
eday never, 0-31 Key end day: 0=Disable 1-31=day
of month
ekey Alphanumeric None - this is the current key in
encrypted format. This parameter is
not configurable.
emon 0-12 Key end month: 0=None
1-12=month
eyear Number Key end year
key Alphanumeric Key (empty)
keyid 0-255 Key ID (0-255)
ll_add Number Link with interface #
ll_ent ““, PPP, ETH Link with interface
sday now,0-31 Key start day: 0=Disable 1-31=day
of month
smon 0-12 Key start month: 0=None
1-12=month
syear Number Key start year