Westermo MR Series - Manual (Page 209)

209 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using the Web Page(s)
The Configure > Protocol Switch page is used to configure the Protocol Switch using the follow-
ing parameters:
Switch from XOT (TCP) to:
This parameter controls the switching of incoming X.25 calls received via XOT. Select the inter-
face to which data should be switched from the drop down list, or select “Off” and the proto-
col switch will not respond to any incoming XOT calls.
Switch from LAPD to:
This parameter controls the switching of incoming X.25 calls received via ISDN LAPD. Select
the interface to which data should be switched from the drop down list, or select “Off” and the
protocol switch will not respond to any incoming LAPD calls.
Switch from LAPB 0 to:
This parameter controls the switching of incoming X.25 calls received via LAPB 0. Select the
inter face to which data should be switched from the drop down list, or select “Off” and the
protocol switch will not respond to any incoming LAPB 0 calls.
Switch from LAPB 1 to:
This parameter controls the switching of incoming X.25 calls received via LAPB 1. Select the
inter face to which data should be switched from the drop down list, or select “Off” and the
protocol switch will not respond to any incoming LAPB 1 calls.
Switch from LAPB 2 to:
This parameter controls the switching of incoming X.25 calls received via LAPB 2. Select the
inter face to which data should be switched from the drop down list, or select “Off” and the
protocol switch will not respond to any incoming LAPB 2 calls.
Switch from LAPB 0 PVC to:
This parameter controls the switching of incoming X.25 calls received via an LAPB 0 PVC.
Select the interface to which data should be switched from the drop down list, or select “Off”
and the pro tocol switch will not respond to any incoming PVC calls on LAPB 0.
Switch from LAPB 1 PVC to:
This parameter controls the switching of incoming X.25 calls received via an LAPB 1 PVC.
Select the interface to which data should be switched from the drop down list, or select “Off”
and the pro tocol switch will not respond to any incoming PVC calls on LAPB 1.
Switch from LAPB 2 PVC to:
This parameter controls the switching of incoming X.25 calls received via an LAPB 2 PVC.
Select the interface to which data should be switched from the drop down list, or select “Off”
and the pro tocol switch will not respond to any incoming PVC calls on LAPB 2.
Switch from XOT PVC to:
This parameter controls the switching of incoming X.25 calls received via an XOT PVC. Select
the interface to which data should be switched from the drop down list, or select “Off” and the
protocol switch will not respond to any incoming XOT PVC calls.
Backup from XOT to:
If any of the Switch from parameters has been set to XOT, and XOT is unavailable, this parame-
ter may be used to specify an alternative interface to switch the X.25 call to. Any of the other
inter faces may be chosen, or “None”. If “None” is chosen, then no backup call will be attempted.