Westermo MR Series - Manual (Page 225)

225 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the radcli command to configure or display RADIUS client settings. To
display current settings for the RADIUS client enter the following command:
radcli ?
where is 0. At present there can only be one instance of RADIUS, i.e. 0, but the
instance parameter has been included to allow for future expansion.
To change the value of a parameter use the following command:
radcli 0
The parameters and values are:
Parameter Values Equivalent Web Parameter
anasid text Primary accounting NAS ID
anasid2 text Secondary accounting NAS ID
apassword text Primary accounting server password
apassword2 text Secondary accounting server password
aserver IP address Primary accounting server IP address
aserver2 IP address Secondary accounting server IP address
inactto number Inactivity timeout (s)
localauth on, off Allow local authorisations
nasid text Primary authorisation NAS ID
nasid2 text Secondary authorisation NAS ID
password text Primary authorisation server password
password2 text Secondary authorisation server password
retran number Maximum re-transmits
retranint number Re-transmit interval (s)
server IP address Primary authorisation server IP address
server2 IP address Secondary authorisation server IP address
For example, to set the inactivity timeout to 20 seconds you would enter:
radcli 0 inactto 20