beautypg.com

Westermo MR Series User Manual

Page 355

background image

355

6622-3201

Web Interface and Command Line Reference Guide

www.westermo.com

Status > W-WAN Module > W-WAN Cell Information

6.12

The Status > W-WAN Module > W-WAN Cell Information page shows the W-WAN specific cell
information. A typical display is shown below.

Note:
This information is only available when a W-WAN context is active.

21 Aug 2003 16:34:21

W-WAN Monitor

BCCH G PBCCH PAT MCC MNC NOM TA RAC

# Cell # 0000 1 -4 234 10 2 00 5F

The parameters are:

BCCH

The ARFCN of the BCCH carrier.

G

Displays GPRS/EDGE status:
0 GPRS/EDGE not available in currently used cell
1 GPRS available in currently used cell
2 GPRS attached
3 EDGE available in currently used cell

4 EDGE attached
-GPRS not supported

Note:
During a voice call or CSD connection GPRS services are not available, and consequently 0 or
- is displayed.

PBCCH

The ARFCN of the PBCCH (Packet Broadcast Control Channel) if present, else “-”. If frequency
hopping is used, this is indicated by “H”. In a W-WAN network, the PBCCH is used to broadcast
packet data specific Packet System Information (PSI). If the PBCCH has not been allocated, this
information is broadcast on the BCCH.

PAT

The Priority Access Threshold. A value of “0”, “1” or “2” means packet access is not allowed
in the cell, a value of “3” means packet access is allowed for priority level 1, and a value of “4”
means packet access is allowed for priority level 1 to 2.

MCC

The Mobile Country Code.

MNC

The Mobile Network Code.

NOM

Network Operation Mode (1 -3). The NOM, is responsible for the capabilities of a W-WAN
network, while the class indicates the mobile phone capabilities. On NOM 1 networks, mobile
phones with the right capabilities can have simultaneous circuit- and packet-switched connec-
tions. On NOM 2 networks, mobile phones can remain attached to the W-WAN networks
when in a voice call but they can’t transmit data at the same time. On NOM 3 networks, mobile
phones can either establish a packet-switched data connection or a circuit-switched voice one
but they need to disconnect from one to establish another.

This manual is related to the following products: