Westermo MR Series - Manual (Page 377)

377 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
X.28 Commands 11.4
Once an X.25 session layer has been established the unit switches to “PAD” mode. In this mode
oper ation of the PAD is controlled using the standard X.28 PAD commands listed in the following
table:
Command Description
CALL Make an X.25 call
CLR Clear an X.25 call
ICLR Invitation to CLR
INPAR? List X.3 parameters of specified PAD instance
INPROF Load or save specified PAD profile
INSET Set X.3 parameters of specified PAD instance
INT Send Interrupt packet
LOG Logoff and disconnect
PAR? List local X.3 parameters
PROF Load or save PAD profile
RESET Send reset packet
RPAR? List remote X.3 parameters
RSET Set remote X.3 parameters
SET Set local X.3 parameters
STAT Display channel status
CALL Make an X.25 Call 11.4.1
The full structure of a CALL command is:
CALL []
where:
is an optional list of codes indicating the facilities to be requested in the call
(separated by commas, terminated with a dash)
is the destination network address.
is any optional user data to be included with the call.
The facility codes supported are:
F Fast select - no restriction
Q Fast select - restricted response
Gnn Closed User Group
Gnnnn Extended Closed User Group
R Reverse charging
N Network User Identity code (NUI)