Westermo MR Series - Manual (Page 74)

74 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the dnssel command to configure or display DNS server selection
settings.
To display current settings enter the command:
dnssel ?
where is 0 - 14.
To change the value of a parameter use the command in the format:
dnssel
The parameters and values are:
Parameter Values Equivalent Web Parameter
pattern domain name Hostname pattern
svr IP address DNS server IP
secsvr IP address Secondary DNS server IP
ent , PPP, Eth Interface
add number Interface #
ipent , PPP, Eth
Source IP Interface
ipadd number Source IP Interface #
For example, to set the host pattern to “*.digi.com” you would enter the command:
dnssel 0 pattern *.digi.com