Westermo MR Series - Manual (Page 81)

81 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
To configure ATM PVC parameters via the command line use the apvc command. To display the cur-
rent settings for an APVC instance enter the command:
apvc ?
where is 0 to 3. To change the value of a parameter, use the command in the format:
apvc
The parameters and values are:
Parameter Values Equivalent Web Parameter
atmanon off, on ATM PVC analysis
debug off, on None - Sends debugging informa-
tion to the command line console.
enabled off, on Enabled
encap pppoa_vcmux, pppoa_llc, pppoe_
vcmux, pppoe_llc, bridged_vcmux,
bridged_llc Encapsulation
vci 0-65536 VCI
vpi 0-255 VPI
Another text command, pingatmmay be used to transmit an OAM F5 loop-back requests over the
specified APVC. The format of the command is:
pingatm []
where: is 0-3
is “end” or “seg”
is an optional numeric parameter specifying the number of loop-back requests transmit-
ted.
Specify endfor end-to-end F5 flow or segfor segment F5 flow. If the count parameter is included
loop-back requests will be sent count times at 1 second intervals, otherwise a single loop-back
request is transmitted immediately.
A typical response to a loop-back request might be:
Sending OAM loopback request on ATM PVC 0
ATM PVC 0: Sent OAM loopback request # 1
ATM PVC 0: OAM loopback response # 1
OAM loopback statistics for ATM PVC 0
Cells sent : 1
Cells received : 1
Success : 100%
Loop-back tests cannot be initiated via the web interface.