Westermo MR Series - Manual (Page 415)

415 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
&W Write SREGS.DAT 17.8
The AT&W command is used to save the current command and S registers settings (for the active
port), to the file SREGS.DAT. The settings contained in this file can be reloaded at any time using the
ATZ command.
The AT&W command may be immediately followed by a profile number, either 0 or 1, to store the
settings in the specified profile, for example:
at&w1
would store the current settings as profile 1. If no profile number is specified, profile 0 is assumed.
All S register values and the following command settings are written by AT&W:
e, &c, &d, &k
&Y Set Default Profi le 17.9
The AT&Y command is used to select the power-up profile (0 or 1). For example, to ensure that the
unit boots up using stored profile 1, enter the command:
at&y1
&Z Store Phone Number 17.10
The AT&Z command is used to store “default” telephone numbers within the unit that may subse-
quently dialled when DTR dialling is enabled or by using the S= modifier in the ATD dial command.
One telephone number may be stored for each ASY port. For example, to store the phone number
0800 123456 as the default number to be associated with ASY 2, use the command:
at&z2=0800123456
If the number of the ASY port is not specified, the number will be stored against the port from
which the command was entered, i.e. entering the command:
at&z=0800123456
from ASY 3 has the same effect as:
at&z3=0800123456
from any port. Once a number has been stored it may be dialled from the command line using the
ATD command with the S= modifier:
atds=3
This means that any stored number can be dialled from any port. If DTR dialling has been enabled
by setting S33=1 for the port, the number associated with that port will be dialled when the DTR
signal for that port changes from Off to On, i.e. DTR dialling can only be used with the number
associated with the port to which the terminal is connected.