Westermo MR Series - Manual (Page 173)

173 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the l2tp command to configure or display the L2TP settings. To display
current settings for the L2TP instance enter the following command:
l2tp ?
where is the number of the l2tp instance. To change the value of a parameter use
the following command:
l2tp
The parameters and values are:
Parameter Values Equivalent Web Parameter
ans off, on Answering
aot off, on Always on tunnel
auth off, on Authenticate
bakremhost IP address Backup remote host
debon 0,1 None - Turn debugging mode on or
off: 0=OFF 1=ON
l1iface isdn, port Layer 1 interface
l1nb number Sync port
listen off, on Listening mode
ll_add UDP Interface #
ll_ent UDP Interface
log_level number None - The logging level for debug
mode
msn text MSN
name text Name
nocallto number Tunnel timeout if no call(s)
remhost IP address Remote host
retxto number Retransmit time(ms)
rnd_srcport off, on Source port off=normal on=variable
secret text Secret
sub text Sub-address
swap_io off, on ServerMode
window 1-8 Window
For example, to set the L2TP window size for l2tp 0 to 4 enter:
l2tp 0 window 4