Westermo MR Series - Manual (Page 93)

93 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Confi gure > Ethernet > ETH n > QOS 4.26
In addition to the QOS parameter on the ETH N standard parameters pages (which are used to
enable quality of service management for that ETH instance), each ETH instance has an associated
QOS instance (ETH 0 maps to QOS 5, ETH 1 maps to QOS 6, etc.). These QOS instances include
10 QOS queues into which packets may be placed when using QOS. Each of these queues must be
assigned a queue profile (from the twelve available profiles defined in the Configure > Quality of
Service > Q Profile pages), and a priority value.
Using the Web Page(s)
Each ETH n > QOS page includes the Link speed parameter at the top followed by a list of queues
with drop-down selection boxes that are used to assign a profile and a priority to each queue.
Link speed (Kbps):
This parameter should be set to the maximum data rate that this PPP link is capable of sus-
taining. It is used when calculating whether or not the data rate from a queue may exceed its
Minimum Kbps setting (as determined by the profile assigned to it) and send at a higher rate (up
to the Max imum Kbps setting).
Queue priorities:
Below this heading is a list of the queues from 0 to 9 alongside each of which are drop down
selec tion lists for assigning profile numbers (from 0 to 11) and queue priorities. The priority may
be set to “Very High”, “High”, “Medium”, “Low” or “Very Low”.