Westermo MR Series - Manual (Page 257)

257 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line use the nat command to configure settings for the static NAT mappings. To
display current settings for a particular mapping enter the command:
nat ?
where is 0 - 49, corresponding to the table entry number. This lists the port number
and the mapped IP address. To change the value of a parameter use the command in the format:
nat
The parameters and values are:
Parameter Values Equivalent Web Parameter
ipaddr IP address Map to IP address
minport 0 - 65535 Min port #
maxport 0 - 65535 Max port #
mapport 0 - 65535 Map to port
For example, to set the IP address for entry 0 in the table to 10.1.2.10 enter the command:
nat 0 ipaddr 10.1.2.10