Westermo MR Series - Manual (Page 70)

70 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the dhcp command to configure or display the DHCP server settings.
To display current settings for the DHCP server enter the following command:
dhcp ?
When configured for Port Isolate operation, models with a built-in hub support multiple DHCP
instances. DHCP instance 0 will run on Ethernet port 0, DHCP instance 1 will run on Ethernet port
1, etc. On models with a single Ethernet port only one DHCP instance is available.
To change the value of a parameter use the following command:
dhcp 0
The parameters and values are:
Parameter Values Equivalent Web Parameter
dns IP address DNS server address
dns2 IP address Secondary DNS server address
domain text Domain name
file text Boot filename
ftp IP address FTP server address
ftproot text FTP root dir
fwdip IP address Forward requests to this server
gateway IP address Gateway address
ipmin IP address Minimum assigned IP address
iprange number IP address range
lease number Lease time (mins)
mask IP netmask Mask
NBNS IP address NetBIOS name server address
nxtsvr IP address Next server address
sname text Server hostname
tftp IP address TFTP server address
For example, to set the IP Address range to 30, enter:
dhcp 0 iprange 30