Westermo MR Series - Manual (Page 290)

290 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
To configure VXN parameters via the command line use the vxncommand. To display current set-
tings for VXN enter the following command:
vxn ?
where is 0.
To change the value of a parameter use the command in the format:
vxn
The parameter options and values are:
Parameter Values Equivalent Web Parameter
connto number Socket connection timeout (s)
debug off, on Enable debug output
keepopen off, on Keep socket open between trans-
actions
mid text Merchant ID
opns off, on Enable automatic online PUK nego-
tiation (OPNS)
opns_svc_name text OPNS service name
opns_svr_name text OPNS server name
pwrinit off, on Perform initialisation with server at
power up
retries number Retries
sdcto number Service discovery timeout (s)
simple off, on None
svcip1 IP address, URL Primary host name
svcip2 IP address, URL Secondary host name
svcname text Service name
svcport1 number Primary port
svcport2 number Secondary port
syncto number Key Synchronisation timeout (s)
tid text Terminal ID
tranto number Transaction timeout (s)
For example, to set the number of retries to 5 you would enter:
vxn 0 retries 5