Westermo MR Series - Manual (Page 228)

228 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
SMTP AUTH Parameters
The following parameters are used to authenticate the unit against the SMTP server.
Username:
This is the password used to authenticate with the SMTP server, and is usually provided by your
SMTP service provider.
Password:
This is the password used to authenticate with the SMTP server, and is usually provided by your
SMTP service provider.
Confirm password:
This parameter is used to confirm the password value entered above.
Using Text Commands
From the command line, use the smtp command to configure or display SMTP settings. To display
current settings for an SMTP instance enter the following command:
SMTP ?
where is 0. At present there can only be one instance of SMTP, i.e. 0, but the instance
parameter has been included to allow for future expansion.
To change the value of a parameter use the following command:
smtp 0
The parameters and values are:
Parameter Values Equivalent Web Parameter
att_limit number Attachment size limit
epassword text None - this is the password in encrypted format. This param-
eter is not configurable.
ll_add 0,1 Interface #
ll_ent PPP Interface
mail_from email address Mail From address
password text Password
port number Server port
reply_to email address Default reply address
retry_dly number Email retry delay
server text Server address
username text Username
userouting off, on Use routing code to determine interface
For example, to set the server address to smtp.myisp.net.uk, enter:
smtp 0 server smtp.myisp.net.uk