Westermo MR Series - Manual (Page 245)

245 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the ntp command to configure or display NTP settings. To display cur-
rent settings for an NTP instance enter the following command:
ntp ?
where is 0. At present there can only be one instance of NTP, i.e. 0, but the instance
parameter has been included to allow for future expansion.
To change the value of a parameter use the following command:
ntp 0
The parameters and values are:
Parameter Values Equivalent Web Parameter
enabled OFF, ON Operational mode OFF = SNTP
ONLY ON = NTP enabled
driftppm number Initial drift compensation (ppm)
server IP address NTP host
bcast OFF, ON Broadcast mode
minpoll number Minimum poll interval
maxpoll number Maximum poll interval
server IP address NTP host 2, 3 or 4
bcast OFF, ON Broadcast mode 2, 3 or 4
minpoll number Minimum poll interval 2, 3 or 4
maxpoll number Maximum poll interval 2, 3 or 4
For example, to set the first server address to 172.16.20.10, enter:
ntp 0 server 172.16.20.10