Westermo MR Series - Manual (Page 307)

307 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the nuaip command to configure or display NUA/NUI to IP mappings.
To display current mappings enter the following command:
nuaip ?
where is the table entry number, i.e. 0 to 255. To change the value of a parameter use the fol-
lowing command:
nuaip
The parameters and values are:
Parameter Values Equivalent Web Parameter
buswto 0-10, 12-15 (see table below) Backup Interface
cud CUD Call Data
ip_port number IP Port
ipaddr IP address IP Address
nua NUA NUA
nui NUI NUI
pid hex numbers PID
swto 0-10, 12-15 (see table below) Interface
Interfaces are coded as follows:
Parameter Value Interface Type
0 Default
1 LAPD
2 LAPB 0
3 LAPB 1
4 XOT
5 LAPD X (actual instance determined by NUA)
6 LAPB 0 PVC
7 LAPB 1 PVC
8 XOT PVC
9 TCP stream
10 UDP stream
12 LAPB 2
13 LAPB 2 PVC
14 VXN
15 SSL
For example, to set up table row 2 from the example you would enter the following series of com-
mands:
nuaip 2 nua 222
nuaip 2 ipaddr 1.2.3.4
nuaip 2 ip_port 45