Westermo MR Series - Manual (Page 220)

220 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Confi gure > Quality of Service > DSCP Mappings 4.71
Each Differentiated Services Code Point (DSCP) value must be mapped to a queue. These mappings
are set-up using the DSCP Mappings configuration page.
Using the Web Page(s)
The Default parameter at the top of the page is used to set-up a default queue, which may be set to
a value from Q0 to Q9. Below this is a list of valid DSCP codes, each of which may also be set to a
value from Q0 to Q9 or Default.
When you change the Default DSCP queue setting, any DSCP codes that are set to Default will
have their queue number changed.
Using Text Commands
From the command line, use the dscp command to configure or display the DSCP mappings. To dis-
play a DSCP mapping enter the following command:
dscp ?
where is a valid DSCP code from 0 to 63, or 64 (see note below).
To change the value of a parameter use the following command:
dscp q
where is a valid DSCP code and is 0 to 9.
To set the default mapping value enter the command:
dscp 64 q
where is the default queue number required between 0 and 9.
Note:
The dscp value of 64 is actually an invalid code and is only used to set up the default priority.