Westermo MR Series - Manual (Page 282)

282 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the tun command to configure or display a GRE tunnel instance. To
display the current settings for a GRE tunnel instance, enter the command:
tun ?
where is 0 to 4.
To change the value of a parameter use the same command in the format:
tun 0
The parameters and values are:
Parameter Values Equivalent Web Parameter
dest IP address Destination
firewall off, on Firewall
IPaddr IP address IP address
ipanon off, on IP analysis
kaactrq off, on Keepalives activate interfaces
kadelay number Keepalive Delay
karetries number Keepalive Retries
mask IP netmask Mask
mtu number MTU
source IP address Source
tunanon off, on Tunnel analysis
For example, to set instance 0 local tunnel interface IP address to 10.1.1.1
tun 0 ipaddr 10.1.1.1
For more information on using and configuring GRE tunnel interfaces, please see the application
note in the support section on our website.