Westermo MR Series - Manual (Page 420)

420 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
at\smib=mib-2.ip.ipaddrtable.ipaddrentry.ipadentifindex
The index identifier for the interface associated with this IP address.
at\smib=mib-2.ip.ipaddrtable.ipaddrentry.ipadentnetmask
The subnet mask associated with the IP address.
at\smib=mib-2.ip.ipaddrtable.ipaddrentry.ipadentbcastaddr
The value of the least-significant bit in the IP broadcast address used for sending datagrams on
the IP address of this interface.
at\smib=mib-2.ip.iproutetable
The iproutetable node contains iprouteentry nodes for each route defined on the unit.
at\smib=mib-2.ip.iproutetable.iprouteentry
at\smib=mib-2.ip.iproutetable.iprouteentry.iproutedest
The destination IP address for the route. An entry with a value of 0.0.0.0 is considered the
default route. Multiple routes to a single destination can appear in the routing table, but access
to such multiple entries is dependant on the table-access mechanisms defined by the network
manage ment protocol in use.
at\smib=mib-2.ip.iproutetable.iprouteentry.iprouteifindex
The index value which uniquely identifies the local interface through which the next hop of the
route should be reached.
at\smib=mib-2.ip.iproutetable.iprouteentry.iproutemetric1
The primary routing metric for the route.
at\smib=mib-2.ip.iproutetable.iprouteentry.iproutenexthop
The IP address of the next hop of the route.
at\smib=mib-2.ip.iproutetable.iprouteentry.iproutetype
The type of route. Valid values are:
1 Valid
2 Invalid
3 Direct
4 Indirect
at\smib=mib-2.ip.iproutetable.iprouteentry.iproutemask
The netmask for the route.