Westermo MR Series - Manual (Page 247)

247 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Daylight savings stop day:
This is the date in the month in which the daylight saving period ends.
Daylight saving stop hour:
This is the hour on the day in which the daylight saving period ends.
Daylight savings adjustment (mins):
The number of minutes to add to the time retrieved from the SNTP server when the time falls
between the daylight savings on and off dates.
Using Text Commands
From the command line, use the sntp command to configure or display SNTP settings. To display
current settings for an SNTP instance enter the following command:
sntp ?
where is 0. At present there can only be one instance of SNTP, i.e. 0, but the instance
parameter has been included to allow for future expansion.
To change the value of a parameter use the following command:
sntp 0
The parameters and values are:
Parameter Values Equivalent Web Parameter
dstmins 0 - 59 Daylight savings adjustment
dstoffday 0 - 31 Daylight savings stop day
dstoffhr 0 - 23 Daylight savings stop hour
dstoffmon None, Jan, Feb, etc. Daylight savings stop month
dstonday 0 - 31 Daylight savings start day
dstonhr 0 - 23 Daylight savings start hour
dstonmon None, Jan, Feb, etc. Daylight savings start month
interval 0-1000 Interval (hrs)
offset -12 - 13 Offset from GMT (hrs)
pwrchk off, on Check on power-up
randintsecs number,number Randomised Interval (s)
server text NTP host
For example, to set the server address to ntp.myisp.net.uk, enter:
sntp 0 server ntp.myisp.net.uk