Westermo MR Series - Manual (Page 180)

180 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line use the mlppp command to set or display MLPPP parameter settings. To
display current settings for MLPPP enter the following command:
mlppp ?
where is 0. To set the value for a parameter enter the command in the format:
mlppp
For example:
mlppp 0 username fred
The parameters and values are:
Parameter Values Equivalent Web Parameter
ddown_delay number 1B->D down delay (s)
ddown_rate number 1B->D down rate (bytes/s)
down_delay number 2B->1B delay (s)
down_rate number 2B-> 1B rate (bytes/s)
dup_delay number D->1B up delay (s)
dup_rate number D->1B up rate (bytes/s)
epassword text None - this is the password in
encrypted format. This parameter is
not configurable.
l_accm hex number Desired local ACCM
l_shortseq off, on Short sequence numbers
password text Password
r_accm hex number Desired remote ACCM
r_chap off, on Request remote CHAP authentica-
tion
up_delay number 1B -> 2B delay (s)
up_rate number 1B -> 2B rate (bytes/s)
username text Username