Westermo MR Series - Manual (Page 298)

298 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
IP connection settings
The Cell Monitor may be configured to transmit the data it retrieves to a specified TCP/IP
address/port. The parameters are as follows:
IP address:
This parameter specifies an IP address to which the unit will attempt to establish a TCP/IP con-
nection. The TCP/IP port must be specified. Any retrieved data is then transmitted over this con-
nection
.
TCP/IP port:
This parameter specifies the destination TCP/IP port number to be used for the connection. The
recently retrieved Cell Monitor information may be viewed on the following web pages:
Status > W-WAN > Neighbour Cells
Status > W-WAN > Serving Cell
Status > W-WAN > W-WAN Cell Info
Using Text Commands
From the command line, the cellmon command can be used to configure the Cell Monitor. To dis-
play the current settings for the Cell Monitor enter the command:
cellmon 0 ?
To change the value of a parameter use the same command in the format:
cellmon 0
The parameters and values are:
Parameter Values Equivalent Web Parameter
att_elog off, on Attach event log
emailfrom text Email From
emailint number Email interval (mins)
emailto text Email To
etemplate filename Email Template
ipaddr IP address IP address
ipport number TCP/IP port
mon_int number Monitoring interval (s)
mong_on off, on GPRS information
moni_on off, on Serving cells
monp_on off, on Neighbour cells
subject text Email subject
For example, to disable monitoring of neighbour cells, enter:
cellmon 0 monp_on off