Westermo MR Series - Manual (Page 260)

260 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the syslog command to configure or display Syslog settings. To display
current settings for the Syslog instance enter the following command:
syslog ?
where is 0-4.
The parameters and values are:
Parameter Values Equivalent Web Parameter
mode UDP, TCP, RFC3195 Operation mode
port 0 - 65535 Port
server IP address Remote syslog server
source_ent ETH, PPP TCP source IP address interface
source_add number TCP source IP address interface #
tcp_to number TCP timeout
priority all, 0 - 7 Priority Selections 0=Emergency
1=Alert 2=Critical 3=Error
4=Warning 5=Notice 6=Info
7=Debug
facility all, 0 - 23 Facility Selections
0=Kernel
1=User
2=Mail
3=System
4=Auth
5=Syslog
6=Lptr
7=Nnews
8=Uucp
9=Clock
10=Auth2
11=FTP
12=NTP
13=LOGAUDIT
14=LOGALERT
15=CLOCK2
16=LOCAL0
17=LOCAL1
18=LOCAL2
19=LOCAL3
20=LOCAL4
21=LOCAL5
22=LOCAL6
23=LOCAL7
Priority and Facility selections can use the keyword “all“, specify an individual number e.g. “1”,
comma separated values e.g. “1,3,6,7”, a range of values e.g. “1-4” or a mixture of both e.g.
“0-3,2,5,9,11 14,19”.
For example, to change the destination of the Syslog 0 messages to 10.1.1.1 enter:
syslog 0 server 10.1.1.1